Recent Plumbing Projects (Pins)

Plumbers replaced all fittings connected to the drip leg and installed a new drip leg in Pflugerville, Texas. After the installation, they tested the system for leaks. No leaks were found. This service ensured safe and reliable gas line connections.

A plumber in Round Rock, Texas inspected a ceiling stain caused by a suspected drain leak. The technician contacted the homeowner to recommend cutting open the ceiling for further investigation and repair. This step was necessary to locate the source of the moisture and assess potential plumbing damage.

Technicians installed vent screws for a water heater located at the center of a home in Austin, Texas. This service helps ensure proper ventilation and safe operation of the water heating system. The placement required careful alignment to support internal airflow and maintain appliance function.

A plumber inspected a hall bathroom faucet in a Buda, Texas home after the customer reported low hot water temperature. The technician diagnosed the issue and confirmed that this faucet was not heating as effectively as others in the house.

A technician pulled and reset a toilet for a home covered by a Select Home Warranty insurance claim in Hutto, Texas. The service ensured proper alignment and function of the toilet fixture following removal.

A plumber in Georgetown, Texas replaced the master bathroom shower-tub fixture cartridge to stop hot and cold water mixing. This work supported accurate leak detection during an ongoing investigation.

Spot On Plumbing installed a new water softener in Georgetown, Texas. The team shut off the main water supply, removed existing loop lines, and connected new PEX piping. They positioned the brine tank, linked it to the softener, and filled it with salt to complete the setup.

Technicians in Austin, Texas shut off the home’s water supply and replaced a damaged shower cartridge after receiving approval from home warranty staff. The team removed the old part and installed a new cartridge to restore proper shower function.

Spot On Plumbing performed water heater maintenance in Round Rock, Texas. The service included flushing the system to remove mineral buildup and support efficient operation. Regular maintenance helps extend the water heater’s lifespan and reduce the risk of performance issues in both tank and tankless units.

Spot On Plumbing installed three toilets and a lavatory with plumbing connections in Austin, Texas. Technicians corrected two misaligned toilet flanges by repositioning and re-anchoring the rings to ensure proper fit and function.

A plumber in Austin, Texas removed a leaking condensate line connected to a newly installed lavatory drain. The plumber replaced it with a new rubber hose and checked the system to ensure there were no visible leaks.

A plumber investigated a water outage in a Georgetown, Texas home. They tested indoor fixtures and confirmed no flow. The technician ruled out the water softener and verified normal flow from the outdoor hose bib, identifying the issue as isolated to the home's interior plumbing.

A plumber investigated a hissing sound behind a master bedroom wall near the water heater. No visible water damage was found. The inspection took place in Georgetown, Texas.

A plumber in Lakeway, Texas removed a rusted drain arm and cleared a stuck pop-up plug. They disassembled the damaged part and placed a bucket under the sink to prevent leaks during the repair.

A technician inspected a water heater in Pflugerville, Texas, after the pilot light failed to ignite. The customer had attempted repairs and replaced parts of the thermopile assembly. The inspection focused on identifying the ignition issue and verifying the condition of replaced components.

A plumbing technician rerouted a new section of gas pipe to a kitchen stove in Austin, Texas. The estimate included city permits and inspection. This service ensured the correct placement of gas lines and compliance with local building codes.

Spot On Plumbing replaced a toilet’s supply line, fill valve, and flapper during a minor toilet rebuild in Georgetown, Texas. This service helps restore proper water flow and flushing function, preventing leaks and improving efficiency.

Plumbers replaced the gasket on a toilet flush valve and added blue dye tablets to the tank for leak detection. This service was completed in Cedar Park, Texas.

A plumber in Round Rock, Texas adjusted framing to fit an overflow drain correctly. The technician removed old washers around the tub and installed new stainless steel washers to ensure a secure and lasting fit.

A plumber repaired a leaking faucet in a hall bathroom in Manchaca, Texas. The customer reported ongoing leaks during use. The technician identified the issue and performed the necessary repair to stop the leak. This service improved water use and prevented potential water damage.

Technicians installed a new reverse osmosis (RO) system and faucet in Leander, Texas. The service included setting up the filtration system and connecting the dedicated faucet to ensure clean drinking water delivery.

A licensed plumber visited a home in Austin, Texas to inspect a persistent leak. The plumber identified the source and assessed the issue for proper repair. This service focused on diagnosing continuous water drips to prevent further water damage and maintain plumbing function.

A technician cleared a jam in a 12-horsepower InSinkErator disposal unit in Cedar Park, Texas. The service restored proper function to the commercial-grade disposal system, ensuring waste management equipment operated without obstruction.

Technicians identified standing water under a vegetable sink island and noted buckling kitchen floors in Round Rock, Texas. This inspection helped locate the source of water damage affecting the flooring structure.

Spot On Plumbing completed main line hydro jetting in Bastrop, Texas. The team used high-pressure water to clear blockages through a cleanout or accessible drain opening. The service included one hour of jetting. Additional time may be needed in kitchen or high-use areas, which could require extra charges.

Plumbers identified a water leak between the home's main shutoff valve and the city meter at the street in Georgetown, Texas. This diagnosis helps prevent further water damage and informs repair planning. The team used onsite inspection to locate the issue without affecting internal plumbing fixtures.

Technicians in Pflugerville, Texas restored power to a tripped breaker, which resolved the garbage disposal issue. They also inspected the tub shoe in an upstairs bathroom to assess its condition and function.

A plumber in Austin, Texas unclogged a sewer main using a cleanout access point. They ran a camera inspection to locate any blockages and confirm the condition of the main sewer line. This process helped identify potential issues or verify that the line was clear.

Spot On Plumbing performed hydro jetting on the main sewer line in Bastrop, Texas. The service included up to one hour of high-pressure water cleaning through a cleanout or accessible entry point in the drainage system to clear blockages and improve flow.

A plumber in Pflugerville, Texas reset a toilet in a guest bathroom by installing a new wax seal, toilet bolts, and supply line. The toilet was tested with multiple flushes, then sealed at the base with caulk. No leaks were found after installation.

Spot On Plumbing installed two new water supply lines and replaced a water heater in either a garage or first-story closet. The team removed and disposed of the old unit. The job did not include any code upgrades. Service took place in Pflugerville, Texas.

A plumber inspected a leaking water supply line in Hutto, Texas. They removed the line and found that the angle stop valve was not shutting off completely. This valve issue was the cause of the drip observed after the water was turned on.

A plumber installed a new Delta single-handle shower valve and trim assembly in Austin, Texas. The plumber verified the valve's function and ensured a proper seal around the trim plate. The installation included connecting to 1/2-inch PEX water piping.

A technician replaced the cold water washer hose in a laundry room in Austin, Texas. The technician confirmed the existing quarter-turn shut-off valve was functioning correctly before completing the hose replacement.

A plumber repaired a twisted copper pipe inside a wall after a customer damaged it while removing a vacuum breaker from a hose bib. This plumbing service took place in Cedar Park, Texas.

Spot On Plumbing performed a whole-home gas leak test in Austin, Texas. The homeowner reported a faint odor and requested a full system check to identify any possible gas leak. The inspection aimed to ensure safety and address concerns about unusual smells in the home.

A plumber replaced the shower valve and installed a new shower trim assembly in the master bathroom. This service took place in Austin, Texas. The work improved water control and fixture function in the shower.

A plumber in Austin, Texas offered solutions to either replace a faulty garbage disposal, repair the existing unit, or adjust the kitchen sink drain piping to improve function. Each option aimed to restore proper drainage and ensure the disposal system met the homeowner's needs.

Spot On Plumbing installed a customer-supplied faucet in Austin, Texas. The team ensured secure connections and proper installation. The service includes a one-year guarantee on workmanship, covering leak-free connections and correct setup, but excludes any warranty on the faucet itself.

A plumber in Austin, Texas removed damaged black iron gas line sections after confirming the gas service was shut off. This service addressed a safety issue and ensured the system was safe for future repairs or replacement.

Technicians performed a hydrostatic sewer test on a residential drainage system in Round Rock, Texas. They filled the drain lines to check for leaks. The system failed to maintain pressure, indicating a leak or break in the sewer line that will require further inspection or repair.

Spot On Plumbing unclogged a sink or shower and used a camera to inspect the line for blockages in Round Rock, Texas. The plumber ensured the drain was clear and accessible before completing the service.

Plumbers removed a loose toilet in Austin, Texas, and found a broken rusted bolt and a damaged flange. They identified the source of instability and informed the customer of necessary repairs. This service addressed mounting issues that caused the toilet to shift.

A plumber in Austin, Texas turned off the home’s water supply, installed a ¾-inch emergency shut-off valve and pressure regulator, added a thermal expansion tank to the water heater, and removed a Grohe shower cartridge assembly to locate replacement parts.

A technician inspected the plumbing in a home in Pflugerville, Texas. The copper flex lines remain functional, but the property contains Kitec piping, which can pose long-term reliability issues. Kitec systems were commonly installed between 1995 and 2007 and often require replacement due to potential failures.

Spot On Plumbing installed two new water supply lines and replaced a water heater in either the garage or a first-story closet. The team removed and disposed of the old unit. No code upgrades were included. Service performed in Georgetown, Texas.

Technicians in Leander, Texas located a sewer line break 4.5 feet from the cleanout at a depth of 1.7 feet. The inspection identified the exact damage point to support targeted repairs and prevent further plumbing issues.

Plumbers completed trench backfilling and removed all job site debris in Austin, Texas. After cleanup, they performed a final walk-through with the customer to confirm the work met expectations.

A plumber routed dishwasher drain and water supply lines through kitchen cabinetry in Austin, Texas. They installed the dishwasher, connected all necessary plumbing, and restored the power. The unit was tested to ensure proper function after installation.

Technicians in Pflugerville, Texas cleared a blocked drain, rebuilt the tubular piping under the sink, and tested the basin to confirm proper drainage and leak-free connections. The system is now working correctly.